Now that our 2m EME Antenna Array is fully installed, we have turned our attention to the set up the EME Station Hardware in our Shack. Our plan is to do a mix of JT65 Digital and CW operation with our 2m EME…
AB1OC-AB1QB 2m EME Station Block Diagram – Phase 1
We’ve created a Phase I Architecture that uses an SDR Dongle and manual selection of Receive Polarity via a switch. We also added a receive splitter and a Transmit/Receive relay in front of an Icom IC-9700 Transceiver which is dedicated to our EME setup to enable both the MAP65 and WSJT10 Software Decoders to operate simultaneously.
This approach has some significant advantages when conditions are poor as one of either MAP65 or WSJT10 will often decode a marginal signal when the other will not.
Special Transmit/Receive hardware was created and added to the sequencing system in our EME station to permit the simultaneous operation of two separate receivers and software decoders for JT65.
The article also covers the installation of a Reference Locking Board in the IC-9700 which allows the IC-9700 to be frequency locked to a clock derived from GPS Satellites.
You can read all about the setup of our EME Station Hardware via the link above.
After a year’s worth of planning and 10 months of construction, we have our new 2m EME Antenna System installed on our EME Tower and working! This stage of our project took about a week…
We’re making good progress on a new 2m EME Antenna System here at AB1OC-AB1QB. Our Antenanns system is up on our EME Tower and we are working through the setup and integration of the equipment and software for our EME Station.
EME Antenna Installation Using A 50 Ft Boom Lift
We rented a boom lift and worked with Matt and Andrew from XX Towers to get our Antenna System up. Our antenna installation took a week to complete and it turned out quite well.
You can read all about this step in our project via the link above. We should have the work needed to bring the rest of our EME Station together sometime during the next few weeks. We can already receive signals that other Hams are reflecting off the moon!
The next major component in our new EME station is the assembly of the Elevation Rotator. This step also involves pre-assembly and testing of the MAP65 Pre-amp Housing, Antenna Power Dividers, Tran…
We are continuing to make progress on our 2m EME Station build. The latest step in the project was to assemble and test the Elevation Rotator and the MAP65 Preamp System. The article at the link above explains what we did to complete this step in our project and to test what is a major sub-system in our 2m EME Station.
MAP65 Preamp Housing
This part of the project includes installation and testing of the MAP65 EME Preamp Housing on the rotator assembly. This unit and the rotator are tested along with a Green Heron Engineering RT-21 Rotator Controller and a MAP65 EME Sequencer.
We are getting close to installing our new 2m EME Array on the tower. The final preparation step in our project will be the final assembly and preparation of a large H-frame that will mount the four antennas in our EME Antenna Array.
We use cookies to ensure that we give you the best experience on our website. If you continue to use this site we will assume that you are happy with it.
